1. Orox
  2. General Discussion
  3. Friday, 25 October 2019

Hello,

 

I have a PX3 model for Ford Mustang. Lately the system is acting up. Every time I turn on the car or put it on drive the reverse camera gets stuck and does not show anything else. Please advise.



Accepted Answer Pending Moderation
1
Votes
Undo

Hi,

try to RESET the panel (on the front panel by paper clip). And test again. If no changes, try below:
If you use a trigger wire for return camera you could disconnect it and switch the yellow RCA (plug from camera) to another video input (e.g. S-CAM). View of the camera can be started manualy in top meny APP list in "Picture" and chose Site view. You will see if the problem is with the channel (Camera, S-CAM, VIDEO) in your panel or the camera is demaged. 

 

Greetings,
StavCo

  1. more than a month ago
  2. General Discussion
  3. # 1
Accepted Answer Pending Moderation
0
Votes
Undo

I have the same problem. It boots to reverse camera and stays until I turn off the car for 3 minutes. This is totally unacceptable as I don’t have AC or heat controls until then. I’ve even replaced the decoder box and nothing. There’s no pin hole reset on this model and this camera is the Mustang stock camera. Anyone have a fix? I think these units are faulty to be honest. 

  • Page :
  • 1


There are no replies made for this post yet.
Be one of the first to reply to this post!